Installation instructions Honda ATC350X 1985 - 1986
What's Included:
(2) Pro Peg Mounts
(1) Front Mount
(2) Pro Peg Nerf Bars
(1) Hardware pack includes: +
(1) 10mm x 110 mm bolt 1986 ATC350X,
(1) 8mm x 110mm bolt 1985 ATC350X,
(2) 8mm x 55mm bolts,
(2) 8mm x 50mm bolts,
(2) 8mm x 20mm bolts,
(2) 10mm flat washers 1986 ATC350X,
(12) 8mm flat washers,
(1) 10mm nylock nut 1986 ATC350X,
(5) 8mm nylock nuts,
(6) 6mm x 70mm bolts,
(12) 6mm flat washers,
(6) 6mm nylock nuts,
(2) aluminum rear nerf bar brackets,
(2) aluminum rear "U" brackets.
(4) Black Nets
(2) Heavy-Duty Steel Construction Foot Peg Mounts powder coated black
(2) S/S Foot Peg Cleats
Aluminum Nerf Bars 1 5/16" x .130 wall aluminum tubing
Compatible: Honda ATC350X 1985 - 1986
Installation Steps:
1. Park and secure your ATC. Place the ATC350X on a flat surface and engage the parking brake. Allow the engine to cool completely before beginning.
2. Remove the stock footpegs. Remove the bolts securing the OEM footpegs on both sides. Set the stock pegs aside. Wipe down the peg mounting brackets with a clean rag to remove any dirt, grease, or debris for a secure fit. Install the new peg mounts using stock bolts. Leave bolts loose for now. Remove motor mount bolt (front upper). 1985 ATC350X uses 8mm bolt 1986 ATC350X uses 10mm bolt. Slide front mount into place and reinstall with 8mm or 10mm bolt depending on what year ATC350X you are installing them on. Leave it loose for now
3. Slide the nerf bars onto front mount and into end of pegs.
Now stand ATC up on rear grab bar. Make sure nerf bars are slid all the way together on the front mount. Now measure and mark 1" from end of nerf bar. Using 21/64 drill bit drill a hole through nerf bar and mount. Put a 8mm x 50mm bolt through the hole drilled using a 8mm flat washer on bolt sides and put a 8mm nylock nut finger tight. Repeat this step for the opposite side.
Set front of ATC back on the ground. Install the the (2) rear nerf bars brackets using 8mm x 20mm bolts and washers. The left bracket bolts to the frame using one of the aluminum "U" brackets. The right bracket bolts to the frame using the second aluminum bracket. Tighten all mounting bolts and torque front motor mount and peg mounting bolts to manufacturer specs.
4. Install Nets, and S/S Pegs
Install the nets. Slide them through the slots and back through the middle slot. Leave them loose until all straps are in place. Adjust nets to desired position.
Slide the S/S pegs over the pins and align holes with pins. Using the 6mm x 70mm bolts slide them through a 6mm washer and then through foot peg and through 6mm washer and the 6mm nylock nut. Leave loose until all bolts are in place. Tighten all 6 bolts securely.
5. Inspect and test.
Give each peg a firm shake to confirm there is no movement or play. Visually inspect the hardware on both sides before riding.
You're Ready to Ride. Your Pro Pegs are now installed and ready for the trail. Note: Always refer to your Honda ATC350X
service manual for model-specific torque specifications. If you have any questions about fitment or installation, contact us before riding. Sales1acracing@gmail.com